X-axis (bed) is not moving..
Hi!
My X-axis (bed) is not moving after a lightning strike a week ago. Everything else is fine. Printing works, but only 2D 🙂 No error codes, self-test fails of course.
Tried this:
1 - Updated to latest FW...
2 - Swapped X-cable with Y-cable on the controller board. Now the bed is moving, but the head (Y-axis) is not -> It has to be the controller board , right?
3 - Measured both +24V from PSU - OK.
4 - Checked all fuses - OK.
Should I order a new controller board, or do anyone know if there is something else I should try before?
Best Regards, Viktor
RE: X-axis (bed) is not moving..
tell us, where you are
somebody near you may have done a mk4, or mk3.9 upgrade, and have a spar controller...
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: X-axis (bed) is not moving..
I'm in Sweden.
RE: X-axis (bed) is not moving..
Removed the board and it's visibly damaged. Ordered a new one.