Weird layer shifting where infill and top layer meet same layer height (eg. model cavities)
Anyone solved weird X-Y layer shifting issue that appears where infill and top layer are at the same layer height.
I suspect on firmware issue?
PS. I have right Belt tension (X 268 Y282), and I don't have any physical obstructions behind/around 3D printer.
RE: Weird layer shifting where infill and top layer meet same layer height (eg. model cavities)
I can't really tell from the picture but this might be a case of the famous bulge disease:
TL;DR: Many suggestions, no universally applicable solution.
https://forum.prusa3d.com/forum/prusaslicer/mitigate-wall-bulge/
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: Weird layer shifting where infill and top layer meet same layer height (eg. model cavities)
I just had a similar shift happen to me less than 12 hours ago. Shifted in Y-axis about 0.051 inches [~1.3mm] toward back of bed. Very near the transition from gyroid infill to top solid infill.
You can read my comment in the PrusaSlicer KB here: