Notifications
Clear all
Thermistor issues??
Since then, when it is heating up, I get this heating graph from octopi.
It's not messing up prints much, although there's more stringing than usual, but is this a sign of impending failure, do you think? And if so, would it be the thermistor or hotend that is the likely candidate?
Many thanks!!
Ce sujet a été modifié il y a 3 years par 01Pad
Publié : 11/08/2021 9:58 pm
PID tune
Can't hurt to do a PID tune. That will run a series of tests to find a good set of parameters for your printer. I wouldn't expect heating it up that one time to be a problem, but there's also no reason not to do a PID tune on occasion.
My notes and disclaimers on 3D printing
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
Publié : 11/08/2021 10:08 pm