Avisos
Vaciar todo
Thermistor issues??
Since then, when it is heating up, I get this heating graph from octopi.
It's not messing up prints much, although there's more stringing than usual, but is this a sign of impending failure, do you think? And if so, would it be the thermistor or hotend that is the likely candidate?
Many thanks!!
Este debate ha sido modificado el hace 3 years por 01Pad
Respondido : 11/08/2021 9:58 pm
PID tune
Can't hurt to do a PID tune. That will run a series of tests to find a good set of parameters for your printer. I wouldn't expect heating it up that one time to be a problem, but there's also no reason not to do a PID tune on occasion.
My notes and disclaimers on 3D printing
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
Respondido : 11/08/2021 10:08 pm