Notifiche
Cancella tutti
Swap filament when using Octoprint
Im 80% through the top right supports for a lack V2 enclosure and the race between being done and the filament running out... is not good. 🙂
When the Prusa runs out of filament I know itll stop and do all the goodies if printing from an SDCard.
How will this be different with Octoprint USB printing?
Best Answer by Jeremy Laurenson:
Works the same....awesome!
Postato : 01/02/2022 1:29 pm
Topic starter
answered:
RE: Swap filament when using Octoprint
Works the same....awesome!
Postato : 01/02/2022 2:14 pm