Notifications
Clear all

Stringing, Extruder Clogged  

  RSS
michael.t45
(@michael-t45)
New Member
Stringing, Extruder Clogged

I have been heavily using my Prusa I3 Mk3 for about a year now and I've recently run into a big problem. The extruder gets clogged constantly, this usually happens when the printer has been printing for more than an hour. The prints are also now super stringing and supports don't come off prints as easily as they did before. I've tried everything I could think off, replace the nozzle, check and clean extruder gears, change filament brands, decrease printing speed, and heating up the nozzle to 260 and letting it drain.

Here are a few photos of the prints and what the filament looks like when I take it out

 

 

I'm currently printing with 3d solutech pla (I've also tried prusa filament) at genetic pla profile in prusaslicer.

I also keep finding these little blobs on my printbed.

Any ideas and thanks in advance

Opublikowany : 20/10/2019 3:43 pm
Share: