Notifiche
Cancella tutti
Set a specific point to retract
I remember at some point I was using Simplify3D and could do this (see image), is there an easy way to do it in PrusaSlicer? (other than using the "seam position" option because I can't specifically choose a position).
Postato : 16/03/2022 6:49 pm
RE: Set a specific point to retract
I have not been able to find a way. I suspect there is not.
--------------------
Chuck H
3D Printer Review Blog
Postato : 17/03/2022 10:29 am
Nino Nobile hanno apprezzato