Set a specific point to retract

Dernier message

RSS

Nino Nobile

(@nino-nobile)

Membre

Set a specific point to retract

I remember at some point I was using Simplify3D and could do this (see image), is there an easy way to do it in PrusaSlicer? (other than using the "seam position" option because I can't specifically choose a position).

Publié : 16/03/2022 6:49 pm

cwbullet

(@cwbullet)

Membre

RE: Set a specific point to retract

I have not been able to find a way. I suspect there is not.

--------------------
Chuck H
3D Printer Review Blog

Publié : 17/03/2022 10:29 am

Nino Nobile a aimé

Statistiques du forum

559 Forums

63 K Sujets

443.7 K Messages

20 En-ligne

67.9 K Membres

Le dernier des messages: Can't Correctly Adjust PINDA Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé