REV) and firmware 3.13.0 Thermal anomalies
Not sure if the issue is on my end (and if it is what and why) but with the latest firmware (while it passes ass the thermal test) I get beeps for thermal anomalies (then carries on) in longer prints (2.5 hours + . More so if using any filaments with additives (IE silk or TPU, ASA). While not the big issue I do keep my ears open for any printer irregular sounds when I am not near the printer. The beeps are not in a regular progression but on the average (once they start) every 60-100 seconds or so. Perhaps I worry too much and the system just notices the temp deviation and adjust accordingly (letting me know a small deviation was noticed?) Any insight from the people who know would be appreciated.
RE: REV) and firmware 3.13.0 Thermal anomalies
Try running through this procedure, it might help. https://help.prusa3d.com/article/temperature-calibration_133266
Aaron
RE: REV) and firmware 3.13.0 Thermal anomalies
Thanks I will give it a go today