Notifications
Clear all
Problem with layer above infill
Hi everyone,
I am printing a part with the standard 15% infill sliced in Prusa Slicer 2.4.2, Prusament PLA.
In the layer above the infill, i get gaps on the outer border, picture attached. I am kind of at a loss on were to start looking for the problem and would appreciate any input.
Jürgen
Posted : 21/05/2022 8:48 am
RE: Problem with layer above infill
15% is a bit on the low side, in my opinion. I'd try 20%. There's also a setting to adjust the infill perimeter overlap that you may want to check out. On the road right now so can't look up the actual name for this setting.
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
Posted : 21/05/2022 3:34 pm
RE: Problem with layer above infill
@jurgen-2
it's not a problem.
This is normal, its the bridging layer, 15% infill is fine, let the print finish.
Enjoy
Swiss_Cheese
The Filament Whisperer
Posted : 21/05/2022 3:49 pm