Printer Restart Incorrectly after Print Pause or Loses Calibration
Hello,
I have a MK3S+ since some months. I noticed at least two times the following weird situation:
1 - I pause the printer while it is printing
2 - After few minutes, I restart the printer/printing
3 - the printer keeps printing with an offset in X and/or Y axis, when compared with the print before the pause. This obviously makes the print a trash.
Similarly: I also noticed once that my Z first layer calibration was lost once. I dont know how/when that happened, but I noticed it after several failed prints and turning on/off the printer several times.
Does anyone have experienced any of those? Is someone of Prusa here?
Thx,
RE: Printer Restart Incorrectly after Print Pause or Loses Calibration
If you want to communicate directly with Prusa, use customer service. Go to the eshop and wait for the chat box to appear in the lower right corner.
Mk3S+,SL1S
RE: Printer Restart Incorrectly after Print Pause or Loses Calibration
This happened again in front of my eyes today (it has happened a couple of other times as well, since I wrote this here). However, the interesting bit of today is that the offset was in Z!!!
I need to talk with Prusa to see why that happens...