Benachrichtigungen
Alles löschen
Power panic intermittent after MK3S+ upgrade
So, as the title implies I've just upgraded from a standard MK3 to MK3S+ and after the upgrade I've gotten a couple of power panics.
There's no actual power outage and the printer gets stuck in power panic mode, after a couple of minutes of intense beeping I get a prompt to continue the print.
The PSU is warm/hot to touch, but I've got no base line on temps so it's hard to say if it's under more load or just getting old.
If it weren't for the fact that just tinkered with the upgrade I would have wrote it of as an old PSU stright away, but now I'm not so sure.
Anybody else had a similar issue?
Any input is greatly appriciated.
Veröffentlicht : 25/11/2022 8:15 am