PINDA not recognizing bed
So after I assembled the printer and began the wizard, during the Z calibration the PINDA fails to stop before pushing the bed down about 3 or 4 mm, then get an error that it failed to detect the bed.
RE: PINDA not recognizing bed
First, check if the PINDA works. The indicator LED should switch if you touch the head with a screwdriver (or any other metal object). To check the connection to the board, you can navigate in the printer menu to "Support -> Sensor Info" and test again.
If it is connected correctly it might be the installation height. The PINDA should be about 1-1.5mm higher than the nozzle. See the guide.
RE: PINDA not recognizing bed
Thanks for the info. I will check that out later today.
RE: PINDA not recognizing bed
After replacing the PINDA device it was determined that the main control board was faulty so Prusa sent out a new one.
RE: PINDA not recognizing bed
has the replacement Einsy arrived yet?
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: PINDA not recognizing bed
Yes it did arrive within a few days. I installed it, reassembled the printer and everything is perfect now.
RE: PINDA not recognizing bed
Super,
Happy Printing,
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK