Notifications
Clear all
Nozzle Temperature at LCD screen
Hi, I am new to 3D printing and using my MK3S has been a bit of a learning curve. The first layer calibration was stressful but all is good now. I have successfully printed my Benchy with PLA and a few other projects. I have also flashed the firmware to 3.9.1.
I have noticed a strange occurrence with the nozzle temperature. I setup for PLA printing nozzle at 215*C and after several minutes of printing the display goes from 215/215* to 210/210*. I have not noticed any problem with the lower nozzle temperature with my prints but was wondering why it would drop by 5*C?
Anyone else notice this behaviour?
Napsal : 29/09/2020 9:06 pm
Topic starter
answered:
RE: Nozzle Temperature at LCD screen
Nevermind, I realized that was the temperature programmed into PrusaSlicer for the first layer vs. subsequent layers.
Napsal : 01/10/2020 9:33 pm