Notifications
Clear all
Not extruding mid print on articulated parts
On-going issue with my Prusa i3 MK3S+. It prints flawless on prints that have no articulated parts...then I go to print my articulated dragon and it stops extruding after the first layer but continues to print. When I go to unload the filament, the end of the filament is swollen like a bubble. I thought it was heat creep at first, however it prints vases, benchies, bottles no problem. Tried a cold pull, cleaned the nozzle with a needle, brushed the gears. Is this hardware or firmware related?
Publié : 13/04/2023 8:32 pm