MK3S+: Yet Another Thermal Anomaly Post. Solved with downgrade 3.11
I read that many and many users around the world have the Thermal Anomaly problem with the firmware 3.13. Before reading all of this problems I thought that was my sensor fault, can we have an official reply? I do not want spend time & money to change a sensor that is not faulty.
My MK3S+ prints flawlessly with 3.11 firmware (I have yet to test 3.12).
So, is a fault of the sensor, of the firmware 3.13 or what?
Thank you
RE: MK3S+: Yet Another Thermal Anomaly Post. Solved with downgrade 3.11
this is a peer to peer forum.
you should use the Prusa 'Chat' option to speak directly with a Prusa Representative
the prusa chat Option opens in the bottom right hand corner of the page about 3 seconds after the page opens.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK