Notifications
Clear all

Mesh bed leveling leaves dobs of plastic behind  

  RSS
WerkRaum
(@werkraum)
Eminent Member
Mesh bed leveling leaves dobs of plastic behind

Since a few days, I get small dobs of plastic on the bed where the mesh bed was touched by the nozzle during the pre-print bed leveling process.

What could cause this? Any idea how to avoid this?

Posted : 05/04/2021 2:15 am
Neophyl
(@neophyl)
Famed Member
RE: Mesh bed leveling leaves dobs of plastic behind

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/excess-filament-during-initial-print/#post-405082

Posted : 05/04/2021 10:08 am
Share: