Notifications
Clear all
Issue with running calibration wiszard after upgrade from mk3 to mk3s using kit.
Just upgraded my Prusa Mk3 to Mk3s. all built no issue self-test runs fine till it gets to XYZ test finds x y and z raises up to top does it usual then goes to run the test hits the top of the rail and then fails as cannot find point? i am not surprised as it's not come off the top of the printer?
any ideas? sure i have seen solution somewhere before. but cannot seam to find it.
Opublikowany : 07/10/2019 10:39 am