Hollowing out top of object

Dernier message

RSS

Stillpointx

(@stillpointx)

Eminent Member

Hollowing out top of object

I have a hollow large bottom cylinder (using 0% infill PIC 1). How do I get the little cylinder at the top to be completely hollow (PIC 2). At the moment the "top solid infill" and the "solid infill" say it will be printed even though I say 0% infill.

I basically want a hollow cylinder at the bottom with a small opening to fill it with.

Best Answer by Stillpointx:

I found away to do this

Publié : 12/09/2020 6:37 am

Stillpointx

(@stillpointx)

Eminent Member

Topic starter answered:

RE: Hollowing out top of object

I found away to do this

Publié : 12/09/2020 4:46 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

22 En-ligne

68.2 K Membres

Le dernier des messages: Prusa Slicer generating floating G-code for printing cones tips Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé