Firmware 3.14.0 Missing Load Filament Option
I upgraded to Firmware 3.14.0. and I do not have an option to Load filament. Downgraded back to Firmware 3.13.3. I now have an option.
RE: Firmware 3.14.0 Missing Load Filament Option
If the filament sensor is ON, it will load when you load filament. If the filament sensor is OFF, I THINK the option returns.
RE: Firmware 3.14.0 Missing Load Filament Option
I have tried with both settings Off & On. and I cannot load filament
RE: Firmware 3.14.0 Missing Load Filament Option
Do you have an MMU attached? If so, turn it Off in Settings. Load Filament option should return (single filament mode).
Hear ye, Hear ye! Step right up folks and get your Government salvation here! Less than $.002 per word! Amazon.com/dp/B0B8XMMFP4
RE: Firmware 3.14.0 Missing Load Filament Option
I do not . Still did not work
RE:
Same here. Seriously Prusa, rather than your endless ads for your overpriced and outdated printers how about some better QA on your firmware releases.
RE: Firmware 3.14.0 Missing Load Filament Option
Why is it gone? i had a lot of trouble with adjusting the stupid mk3s sensor. also problems now in selftest X-axis..
RE: Firmware 3.14.0 Missing Load Filament Option
Same here, Prusa come back to quality and clear descriptions! Please...
---
In God we trust. All others must bring data!
RE: Firmware 3.14.0 Missing Load Filament Option
DO bring the load option back - please!
RE: Firmware 3.14.0 Missing Load Filament Option
Just put my mk3s+ in an enclosure and updated firmware, now it won't feed filament, it was working just a couple of days prior. I have a new sensor board on order, but now I'm not sure if it's the board or firmware. This firmware was vetted for the for the MK3S+?