Notifications
Clear all
Error: Line Number is not Last Line Number+1 when trying to start a new print after one is done.
I've had issues with pronterface going bananas and ultimately crashing each time I'm done with a print and want to start a new one because it just goes into an infinite loop of the above serial communication.
I have downgraded the FW version trying to fix it, and it will hopefully work, but using previous firmware versions shouldn't be the solution, so I'm curious of anybody has a solution that would work with FW3.13.1?
This topic was modified 1 year temu by BertoLaDK
Opublikowany : 08/09/2023 6:45 pm
RE: Error: Line Number is not Last Line Number+1 when trying to start a new print after one is done.
Just want to add to this thread that this is a known issue with Pronterface at least since 3.12. For some reason this doesn't happen when using Octoprint.
Relevant Github reports:
Opublikowany : 10/09/2023 9:48 pm