Error: Line Number is not Last Line Number+1 when trying to start a new print after one is done.
 
Notifications
Clear all

Error: Line Number is not Last Line Number+1 when trying to start a new print after one is done.  

  RSS
BertoLaDK
(@bertoladk)
Member
Error: Line Number is not Last Line Number+1 when trying to start a new print after one is done.

Error:Line is not last Line Number+1

I've had issues with pronterface going bananas and ultimately crashing each time I'm done with a print and want to start a new one because it just goes into an infinite loop of the above serial communication.

I have downgraded the FW version trying to fix it, and it will hopefully work, but using previous firmware versions shouldn't be the solution, so I'm curious of anybody has a solution that would work with FW3.13.1?

This topic was modified 3 months ago by BertoLaDK
Posted : 08/09/2023 6:45 pm
gudnimg
(@gudnimg)
Eminent Member
RE: Error: Line Number is not Last Line Number+1 when trying to start a new print after one is done.

Just want to add to this thread that this is a known issue with Pronterface at least since 3.12. For some reason this doesn't happen when using Octoprint.

Relevant Github reports:

Posted : 10/09/2023 9:48 pm
Share: