Cura 5 and i3MK3S+
I thouoght I would try Cura 5 to see how it would print. Everything looks fine in the preview but
prints, or attempts to print, in the lower left and the wrong size. Attached image show what the model should look like
and the correct location. The i3MK3S is listed as an available printer.
should lo
ok like and the correct position.
RE: Cura 5 and i3MK3S+
First of all, Cura 5 has known issues. Several.
I have an Ultimaker as well as a Prusa and I backed out of 5 when it would not let me do a full-plate build. Lots of other issues have been reported in the Ultimaker forum.
I am using 4.12.1 and it works reasonably well on the MK3S, but originally the profile had a few of the speeds much too fast!
RE: Cura 5 and i3MK3S+
Thank you for the reply. I was looking forward to using it and trying out the many options. But...it looks like it isn't ready, at least
for the Prusa owners. Hopefully an update will resolve some of the issues. I'll go back to the Prusa slicer for now.