Notifications
Clear all
Counting up on time, other issues. 3.10.1
I recently upgraded to 3.10.1 on a S+ which was assembled from factory last fall.
I had a print where it was moving back and forth in x for the width of a 2" print, but no and other wacky actions.
I reflashed with a newly d/l 3.10.1, reinstalled the slicer. Now the time counts up instead of down, so I don't know how much time is left on the print; the hotend shows 0 temp till the bed heats (both heated at the same time before), and it even stopped (two different prints) at 3/4 of a print. I reflashed (the second time), no changes. Will backrev to 3.10.0.
Any ideas?
Publié : 26/01/2022 8:08 pm