Consistent Stringing - Tuning not yielding results
Good day everyone,
First time posting, but I've been printing and using online resources for upwards of 5 years. I've solved many many issues with my old ender 3 and since upgrading to a Mk3s+ I have had 0 issues till now.
The issue is of consistent stringing that refuses to be tweaked away. I have popped a brand new reel of PLA and confirmed it prints fine on my Ender 3, but on my MK3S it leaves constant strings.
Things I have tried:
-Changed Nozzle
-Reset slicer profile to defaults
-Gone from 35mm/s-75mm/s retraction speed
-Gone from 0mm to 1.2mm retraction distance
-Turned off Wipe
-Confirmed Linear Advance tuning
-Confirmed extrusion multiplier calibration
Kinda at an impass here as I have perfect prints from about a month ago that are flawless with the same PLA that started stringing like mad out of nowhere. See the attached photo for the default settings results. I couldn't get anything better than that.