Notifiche
Cancella tutti
Can't load and unload filament
Hello,
Each time I try to unload filament, I have the message 'please pull out filament immediately', but I don't see any filament in there.
Each time I try to load my filament, the filament motor tries to push down the filament, but it doesn't go in.
I had ticking that disappeared.
The problem appeared when my printing stopped because the filament was over, and it stayed like this for many hours.
Postato : 23/09/2022 7:31 pm
RE: Can't load and unload filament
I would disassemble the extruder. There is something stuck of you have a bad sensor.
--------------------
Chuck H
3D Printer Review Blog
Postato : 26/09/2022 12:39 am