Notifications
Clear all

Can't load and unload filament  

  RSS
Brakovic
(@brakovic)
New Member
Can't load and unload filament

Hello,

Each time I try to unload filament, I have the message 'please pull out filament immediately', but I don't see any filament in there.

Each time I try to load my filament, the filament motor tries to push down the filament, but it doesn't go in.

I had ticking that disappeared.

The problem appeared when my printing stopped because the filament was over, and it stayed like this for many hours.

Posted : 23/09/2022 7:31 pm
cwbullet
(@cwbullet)
RE: Can't load and unload filament

I would disassemble the extruder.  There is something stuck of you have a bad sensor.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 26/09/2022 12:39 am
Share: