Avisos
Vaciar todo
Calibrations failed after 4 points calibration
Hello,
I tried a new filament that wouldn't print normally. I tried another one and same thing, so I came back to my normal filament that started to stick and clug. I decided to do a normal calibration with the wizzard and after that it succeeded on the 4 points calibration, it failed. The extruder is supposed to pull up and it hits the bed, the right Z pole goes down and there is a difference between left and right. I got it leveled again and started the whole operation but after the 4 points calibration it failed to pull up and hits the bed again. I'm lost... it all work well for months and all of a sudden I get this.
Any ideas?
Este debate ha sido modificado el hace 7 months por zylaris
Respondido : 07/10/2023 2:04 am