Benachrichtigungen
Alles löschen
Calibration cube - how to correct steps?
Hi all,
Printing a load of stuff and I notice my MK3s is lumbering some way behind my P1s in terms of accuracy, so I was hoping to tune the steps a bit.
I've printed a calibration cube and I'm getting the following dimensions from an attempted 20mm cube:
Z: 20.44
X: 20.11
Y 20.05
Think Y seems pretty good, but how can I tune the steps for the X and Z axes a bit?
Had a google and firmware modification is suggested (although not highly recommended) - am I missing something obvious in Prusaslicer or the like!?
Dieses Thema wurde geändert Vor 1 year 2 mal von Alphabeta777
Veröffentlicht : 17/10/2023 12:33 pm