Z-Offset resetting...maybe?

Dernier message

RSS

Dustin

(@dustin)

Eminent Member

Z-Offset resetting...maybe?

I'm using Octoprint with my MK3 and I'm trying to dial in some PET, and I swear that my Z-offset keeps resetting, even though it shows on the printer its where I left it. Am I missing something? Is Octoprint doing something I'm unaware of?

Publié : 31/03/2021 8:01 pm

Dan Rogers

(@dan-rogers)

Noble Member

RE: Z-Offset resetting...maybe?

I don't have any challenges with live Z and Octoprint. I can adjust it, it is right where I left it. What else changed?

Publié : 31/03/2021 10:14 pm

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

20 En-ligne

67.8 K Membres

Le dernier des messages: Whose upgrading to Core One? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé