Notifications
Clear all
Z calibration problem
Hello,
I have a problem with Z calibration on a Mk3S Prusa.
I do Z calibration, first layer calibration, everything is ok. I print one piece, and then when I want to print another piece the Z calibration is no longer saved and I have to recalibrate everything again.
I never have this problem until now.
Please tell me why this is happen and how i can to fix it.
Thx!
This topic was modified před 3 years 2 times by marius
Napsal : 02/06/2021 2:52 pm
RE: Z calibration problem
I would recommend you contact support via eChat on this one. I have never seen this on any of my 8 Mk3S.
--------------------
Chuck H
3D Printer Review Blog
Napsal : 12/06/2021 12:34 pm