Notifications
Clear all
Stránka 2 / 2
Předchozí
Topic starter
answered:
RE: Weird layers alignment
All the screws are tightened and one is against the flat side.
The smooth rods are in good condition. Sure not as new but good
Trapezoid nut I was talking about
I don't see any prior mentioning of the trapezoid nut in your previous posts, so this picture was out of context. Again, I'd check the grub screws, which I mentioned before and Joan posted pictures of.
Napsal : 29/01/2023 9:56 pm
Topic starter
answered:
RE: Weird layers alignment
the POM nut on the lead screw?
(Black thingie)
Yes exactly. Is it possible that if it’s ruined it causes that layers?
Napsal : 30/01/2023 8:40 am
RE: Weird layers alignment
Sure. Could be. Also, the screws on this one should not be as tight as other screws but a bit loose.
Napsal : 30/01/2023 11:46 am
Topic starter
answered:
RE: Weird layers alignment
Oh, why shouldn’t be tight?
Sure. Could be. Also, the screws on this one should not be as tight as other screws but a bit loose.
Napsal : 30/01/2023 11:57 am
Stránka 2 / 2
Předchozí