Notifications
Clear all
Tapezoidal nuts installed upside down?
I have two MK3S printers and one MK3S+. Although one MK3S has been printing fine with no problems, I noticed recently the trapezoidal nuts are installed upside down. Should I flip them over or just ignore? It seems to be working fine, but it looks like a simple thing to do.
Posted : 18/11/2023 7:54 pm
Topic starter
answered:
RE:
FYI, issue has been fixed. The attached photo shows the nuts upside down. I was doing some PM on this printer so I flipped them over. Pretty simple, it takes a little care to get the inner nut engaged on the screw. After a z-calibration the printer is printing just as before.
This post was modified 11 months ago by G Bell
Posted : 08/12/2023 10:01 pm