Notifications
Clear all

Sensor not triggering error  

  RSS
Sheeba2020
(@sheeba2020)
New Member
Sensor not triggering error

I’m needing help. 

I have new about a month or so old MK3S. 

I had to remove a piece of petg filament that was stuck in the ptfe tube after I ran out during a print.  I disassembled and Re-assembled extruder by Prusa protocol and now when try I to print I get this error.  I have tried to recalibration...no luck.  The hotend is seated in the correctly.  Not sure what to do

 

Publié : 04/06/2020 3:09 am
Sheeba2020
(@sheeba2020)
New Member
Topic starter answered:
RE: Sensor not triggering error

No debris on the nozzle.

Publié : 04/06/2020 3:10 am
Sheeba2020
(@sheeba2020)
New Member
Topic starter answered:
RE: Sensor not triggering error

There not any debris on the nozzle.

Publié : 04/06/2020 3:13 am
Partager :