Notifications
Clear all
Sensor not triggering error
I’m needing help.
I have new about a month or so old MK3S.
I had to remove a piece of petg filament that was stuck in the ptfe tube after I ran out during a print. I disassembled and Re-assembled extruder by Prusa protocol and now when try I to print I get this error. I have tried to recalibration...no luck. The hotend is seated in the correctly. Not sure what to do
Napsal : 04/06/2020 3:09 am
Topic starter
answered:
RE: Sensor not triggering error
No debris on the nozzle.
Napsal : 04/06/2020 3:10 am
Topic starter
answered:
RE: Sensor not triggering error
There not any debris on the nozzle.
Napsal : 04/06/2020 3:13 am