Notifications
Clear all

Rough sides on Benchy when printing 0.1mm DETAIL  

  RSS
Printerman
(@printerman-3)
Eminent Member
Rough sides on Benchy when printing 0.1mm DETAIL

I have tried printing a Benchy with 0.1mm DETAIL using generic PLA, and the sides are rough. It affects a couple of parts of the print, but the edges of this area are pretty straight. When printing with 0.2mm setting it is not a problem, and turns out great. The problem is on the port side of the bow.

Has anyone got a clue as to what coulde be causing this?

Opublikowany : 27/11/2022 7:11 pm
Share: