Notifications
Clear all
Likely cause of slow oozing around nozzle?
I am getting a little bit of filament oozing out around the nozzle at the point where the nozzle threads into the silver heat block. It's not much, but after a 6hr print there's enough there that gives me cause for concern. At rare times a little bit of that has come off onto the current print.
What is the likely cause of this?
Posted : 28/09/2020 12:34 am
RE: Likely cause of slow oozing around nozzle?
PTFE tubing not fully inserted or heatbreak not correctly inserted.
--------------------
Chuck H
3D Printer Review Blog
Posted : 28/09/2020 6:00 pm
1 people liked
Topic starter
answered:
RE: Likely cause of slow oozing around nozzle?
Thanks. I think it likely that the heatbreak has untwisted from the nozzle a little.
Posted : 28/09/2020 6:14 pm