Notifications
Clear all
Initial layer line overlap issue
Hello Everyone,
I printing a master spool for filament refills. In the initial layer, I notice some of the line the printer are not touching each other or the line width is not overlapping creating a small gap (please see picture). The printer laying down these line in a diagonal manner.
I would like to learn the cause of this issue and a possible fix?
Thank you.
Attachment removed
This topic was modified 5 years temu by Henry
Opublikowany : 03/09/2019 6:03 am
RE: Initial layer line overlap issue
Opublikowany : 03/09/2019 10:59 am