Notifications
Clear all

Initial layer line overlap issue  

  RSS
Henry
(@henry-5)
Eminent Member
Initial layer line overlap issue

Hello Everyone, 

I printing a master spool for filament refills. In the initial layer, I notice some of the line the printer are not touching each other or the line width is not overlapping creating a small gap (please see picture).  The printer laying down these line in a diagonal manner.  

I would like to learn the cause of this issue and a possible fix? 

Thank you. 

Attachment removed
This topic was modified před 5 years by Henry
Napsal : 03/09/2019 6:03 am
vintagepc
(@vintagepc)
Member
RE: Initial layer line overlap issue

https://shop.prusa3d.com/forum/assembly-and-first-prints-troubleshooting-f62/life-adjust-z-my-way-t2981.html

Napsal : 03/09/2019 10:59 am
Share: