Notifications
Clear all

Fiber Spool Holder STL  

  RSS
Rich R
(@rich-r)
Active Member
Fiber Spool Holder STL

Does anyone know where I can find the STL or gcode for the MK3+ dual fiber spool holder?  It came in 3 pieces (2 designs) but it's not in the zip for the general parts for it.  I found an older design but it's one-sided vs. the 2.

Posted : 08/05/2021 4:16 pm
Neophyl
(@neophyl)
Famed Member
RE: Fiber Spool Holder STL

That's because its not printed but injection molded.

Posted : 08/05/2021 4:20 pm
Baklin
(@baklin)
Reputable Member
RE: Fiber Spool Holder STL

Almost at the bottom of this page.

https://www.prusa3d.com/prusa-i3-printable-parts/

Posted : 08/05/2021 4:49 pm
Neophyl
(@neophyl)
Famed Member
RE: Fiber Spool Holder STL

@baklin

Yes but that's not the one the OP was requesting.  That's the old single sided one they mentioned.  The newer double sided one is not a 3d printed part and is injection molded.

Posted : 08/05/2021 5:03 pm
Rich R
(@rich-r)
Active Member
Topic starter answered:
RE: Fiber Spool Holder STL

@neophyl

Thanks, that certainly explains it!

Posted : 09/05/2021 1:05 am
Share: