Change steel sheet, always First Layer Calibration?
Hi,
When I change steel sheets on the hotbed is "First Layer Calibration" always what I need to do? I have a smooth and a textured sheets, they are different thickness.
thanks,
Monte
MK3, firmware 3.14.0
Best Answer by Diem:
Every time you use a new sheet recalbration is necessary - but you can store the details against the name of the sheet for later reload - LCD menu.
Cheerio,
Every time you use a new sheet recalbration is necessary - but you can store the details against the name of the sheet for later reload - LCD menu.
Cheerio,
RE: Change steel sheet, always First Layer Calibration?
Thanks. Didn't know value could be stored.
RE: Change steel sheet, always First Layer Calibration?
If there only where a place to look things like that up....
Wait! https://help.prusa3d.com/article/steel-sheet-profiles_1955
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!