Avisos
Vaciar todo
Z calibration issue
I’m new to 3d printing and recently obtained a used device, also first time post on this forum.
It was latest firmware. It was printing fine until a Z calibration issue occurred when starting new print. I then tried xyz and Z calibration menus with same result. Please see the recorded video for details
thanks!
any help is appreciated
Respondido : 15/05/2023 5:33 pm
RE: Z calibration issue
i think you need to hold paper so its smooth on the bed
Respondido : 18/05/2023 3:31 pm
Cheerio,
Respondido : 19/05/2023 11:45 am