Notifications
Clear all

Y-Axis Uneveness  

  RSS
rory.w
(@rory-w)
New Member
Y-Axis Uneveness

I've been having issues with my y-axis on my Prusa MK3. I've manged to clean it up a lot by adjusting the physical axis, but I don't know how to move forward with fixing it. I've attached images of the most recent test cube I made. Any ideas?

Opublikowany : 10/07/2018 6:33 pm
themzlab
(@themzlab)
Estimable Member
Re: Y-Axis Uneveness

wow, that's really bad : (

check to see that the set screw is tight on the pulley and that is is over the top of the flat on the shaft.

Opublikowany : 10/07/2018 7:02 pm
rory.w
(@rory-w)
New Member
Topic starter answered:
Re: Y-Axis Uneveness

That was it. Thank you so much

Opublikowany : 10/07/2018 8:56 pm
Share: