Notifications
Clear all
Y-Axis Uneveness
I've been having issues with my y-axis on my Prusa MK3. I've manged to clean it up a lot by adjusting the physical axis, but I don't know how to move forward with fixing it. I've attached images of the most recent test cube I made. Any ideas?
Napsal : 10/07/2018 6:33 pm
Re: Y-Axis Uneveness
wow, that's really bad : (
check to see that the set screw is tight on the pulley and that is is over the top of the flat on the shaft.
Napsal : 10/07/2018 7:02 pm
Topic starter
answered:
Re: Y-Axis Uneveness
That was it. Thank you so much
Napsal : 10/07/2018 8:56 pm