Notifications
Clear all
XYZ Dimensional Error
Hi,
I've had my MK3 (factory assembled) for a while, but lately I need to print parts for a mechanical assembly. My parts aren't fitting properly, and when I measured, it turns out my prints are about 1% too small (the 100 mm bar I printed measures 99.2 mm). I already tried the self-calibration with no improvement, is there a better way to calibrate the machine?
Opublikowany : 19/12/2019 2:06 am
RE: XYZ Dimensional Error
What material are you printing? All plastics will shrink a little as they cool. Some plastics have higher shrinkage than others. If the scale error is consistent, then I suggest just scaling the part by 101% in Slicer.
Opublikowany : 19/12/2019 11:52 pm