Benachrichtigungen
Alles löschen
XYZ Calibration failing after 4th calibration point
I just built my MK3S and the XYZ calibration keeps failing after the 4th point with the "please consult the manual" message. I have never even watched a 3D printer in operation so I'm not sure where to start. I loosened and re-tightened the bed screws and tried both raising and lowering the PINDA sensor, but I keep getting the same message. The nozzle isn't hitting the paper, but it's quite low. I'm desperate- any suggestions would be great!
some images and a video: https://photos.app.goo.gl/dy1apJf7ogoRmKu96
Veröffentlicht : 20/09/2019 5:26 pm
RE: XYZ Calibration failing after 4th calibration point
https://help.prusa3d.com/article/fja7hbb22y-xyz-calibration-error-messages-mk-3
Veröffentlicht : 21/09/2019 9:01 pm
RE: XYZ Calibration failing after 4th calibration point
I think the third picture looked like X-axis is bit off leveled.
Veröffentlicht : 22/09/2019 2:30 am