Notifications
Clear all
XYZ Calibration Failed
Noob here. I got this used MK3S but the previous owner did not have the manual. I am trying to run the calibration wizard, but failing the xyz part. It started well as it was circling and not hitting the paper. However, after 10 to 20 sec in, it started to drag the paper. The selftest passed, belt test passed. I am not too sure how to troubleshoot this.
I had three failed print as it was dragging/knocking off my print during a print before I calibrate the printer.
Any advice or help would be greatly appreciated.
Posted : 08/10/2025 2:19 am