X/Y Axis Slightly Skewed After XYZ Recal

Ultimi post

RSS

Your Fave Mull...

(@your-fave-mullet)

Active Member

X/Y Axis Slightly Skewed After XYZ Recal

Hi Everyone!

I performed an XYZ calibration after a move around in the house. The printer was dormant for some time and collected a bit of dust, which I cleared off of course. After calibration I got the message on the LCD that the X/Y axis is slightly skewed and although I am aware that the software makes adjustments for this, I would prefer the axis to be perpendicular so that it does not haunt me at night.

I have attached some photos of the XYZ cal stats. If anyone could inform me of what could be causing this and can recommend options on rectifying this issue then I would greatly appreciate it!

Thank you!

Liam