Notifications
Clear all

X-Axis Skip  

  RSS
tucker.m
(@tucker-m)
New Member
X-Axis Skip

Just finished assembling an I3 MK3. I've tried a few different prints, pre-sliced and sliced myself, but am still getting an x-axis shift during each layer, not in between. Any thoughts as to why this might be happening? I've checked the wiring three times, but it was all fine.

Here's an example of the layer shift:

Posted : 25/01/2019 6:48 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: X-Axis Skip

is your x toothed wheel screwed on tightly?

try disabling crash detection

joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 25/01/2019 7:08 pm
Share: