Benachrichtigungen
Alles löschen
X-Axis Skip
Just finished assembling an I3 MK3. I've tried a few different prints, pre-sliced and sliced myself, but am still getting an x-axis shift during each layer, not in between. Any thoughts as to why this might be happening? I've checked the wiring three times, but it was all fine.
Here's an example of the layer shift:
Veröffentlicht : 25/01/2019 6:48 pm
Re: X-Axis Skip
is your x toothed wheel screwed on tightly?
try disabling crash detection
joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Veröffentlicht : 25/01/2019 7:08 pm